KODAK EASYSHARE LS443 Zoom Digital Camera — User's Guide


Table of Contents > Taking Pictures > Setting Exposure Compensation

2 Taking Pictures

Setting Exposure Compensation

Use Exposure Compensation to control how much light enters the camera. This setting is useful for taking pictures in very large rooms, under low light, without a flash.

Adjust the exposure by plus or minus 2 steps in 1/2-step increments.

NOTE: Exposure Compensation cannot be used with Long Time Exposure.



  1. In any Still mode, press the Menu button.

  2. Move the joystick to highlight Exposure Compensation , then press the OK button.


  3. Move the joystick to select the Exposure Compensation setting.

  • If pictures are too light, decrease the value.

  • If pictures are too dark, increase the value.

  4. Press the OK button to accept the change.

  5. Press the Menu button to exit the menu.

  6. Use the LCD to frame your subject. Press the Shutter button half-way to set the focus, then continue pressing completely down to take the picture.

This setting remains until you move the Mode dial or turn off the camera.



Previous Next