KODAK EASYSHARE LS443 Zoom Digital Camera — User's Guide


Table of Contents > Installing the Software > Install the Software

7 Installing the Software

Install the Software

For information on the software applications included on the KODAK EASYSHARE Software CD, see the Quick Start Guide or the KODAK EASYSHARE Software Help.
CAUTION:
Install the software from the KODAK EASYSHARE Software CD before connecting the camera or dock to the computer. Failure to do so may cause the software to load incorrectly.

  1. Before you begin, close all software applications that are open on your computer.

  2. Place the KODAK EASYSHARE Software CD into the CD-ROM drive.

  3. Load the software:

WINDOWS-based computer—if the first install window does not appear, choose Run from the Start menu and type d:\setup.exe where d is the drive letter that contains the CD.

MAC OS 8.6 or 9.x—on the install window, click Continue.

MAC OS X—double-click the CD icon on the desktop, then click the Install icon.
  4. Follow the on-screen instructions to install the software. If prompted, restart the computer when the installation is complete.

  • Select Typical to automatically install the most commonly used applications.

  • Select Custom to choose the applications you wish to install.

NOTE: When prompted, take a few minutes to electronically register your camera and software. This lets you receive information regarding software updates and registers some of the products included with the camera. You must be connected to your Internet service provider to register electronically. To register later, see www.kodak.com/go/register.

For further installation help, see the Quick Start Guide.



Previous Next