Kodak EasyShare DX6490 zoom digital camera — User's Guide

Table of Contents > Using the Camera Dock 6000 > Installing the Custom Camera Insert

---

9 Using the Camera Dock 6000

Installing the Custom Camera Insert

A universal insert is pre-installed in the camera dock. It allows all Kodak EasyShare CX/DX6000 series and LS600 series cameras to use the camera dock.

A custom insert* is included with your camera. It provides a perfect fit for your Kodak EasyShare DX6490 zoom digital camera.

Remove the Universal Insert

		1. Place your thumbs against the front of the universal insert. Press in and lift.
		2. Lift the side edge of the insert, then remove the insert from the dock.
		3. Save the universal insert as a spare.

Install the Custom Insert

		1. Position the custom insert so the cutout lines up with the camera dock connector.
		2. Fit the insert into the groove in the dock. Snap it into place.

* If your camera is packaged with a camera dock 6000, the custom insert is pre-installed in the camera dock, and the universal insert is not included.

Previous Next