Kodak EasyShare DX7440 zoom digital camera — User's guide


Table of Contents > Troubleshooting > Camera ready light status

7 Troubleshooting

Camera ready light status

Status Cause

Ready light glows steady green.

Shutter button is pressed halfway down. Focus and exposure are set.

Ready light blinks green.

Picture is being processed and saved to the camera.

Pictures are being transferred to computer; camera is connected.

Camera firmware upgrade is in process.

Ready light glows steady orange.

Camera is in Favorites mode.

Ready light blinks orange.

Flash is not charged. Wait. Resume picture taking when the light stops blinking and turns off.

Auto-exposure or auto-focus are not locked. Release the Shutter button and recompose the picture.

Ready light blinks red and camera turns off.

Battery is low or exhausted. Recharge the battery (Charging the battery).

Ready light glows steady red.

Camera's internal memory or card is full.

Transfer pictures to the computer (Transferring and printing pictures), delete pictures from the camera (Deleting pictures and videos), switch image storage locations (), or insert a card with available memory (Storing pictures on an SD/MMC card).

Camera processing memory is full. Wait. Resume picture taking when the light turns green.

Card is read-only. Change image storage location to internal memory (), or use a different card.

Memory card speed is slow. Card cannot be used to take videos.

Change storage location to internal memory (). Use this card to take pictures only.

Still having problems?

Visit www.kodak.com/go/dx7440support, or see Getting help.



Previous Next