Kodak EasyShare printer dock plus series 3 — User's Guide


Table of Contents > Getting started > Installing the custom camera insert

1 Getting started

Installing the custom camera insert

IMPORTANT: Use the custom insert that came with your digital camera to dock the camera, otherwise the camera may not fit on the printer dock.


  • Locate and install the custom insert included with your camera.

    IMPORTANT: Depending on your camera connector, you may also need to use the optional Kodak dock adapter kit D-26.*

    1. Remove any packing material covering the connector.

    2. Place the rear tabs of the insert in the slots toward the back of the printer dock.

    3. Press the front of the insert down and snap into place.

* Contact customer support for a dock adapter if it is not included with your product. Visit www.kodak.com/go/dfiswwcontacts.

For Kodak EasyShare camera and dock compatibility, visit www.kodak.com/go/adapterkitchart.



Previous Next