Kodak EasyShare printer dock plus series 3 — User's Guide

Table of Contents > Getting started > Installing and removing the color cartridge

---

1 Getting started

Installing and removing the color cartridge

1. Open the cartridge door on the side of the printer dock.
		2. Check to make sure there is no slack in the color cartridge ribbon. To remove slack, push in on the cartridge spool, then rotate the spool clockwise. IMPORTANT: Be careful not to rotate the spool more than that necessary to remove slack. Doing so could reduce the number of prints you are able to make.
		3. Slide the color cartridge in, label side up, with the arrow pointing toward the printer dock. Push the cartridge until it "clicks" into place.
		4. Close the cartridge door.

		To remove the color cartridge, open the cartridge door, then push up on the green lever and slide the cartridge out.

IMPORTANT:

The color cartridge may lock in place if there is a paper error. Do not attempt to remove the cartridge without first clearing the paper error. Make sure the Paper light is off before attempting to remove the cartridge (see Paper light under Status lights).

		During printing, or upon connecting the power, the Color cartridge light glows amber for 10 seconds if there are five or fewer prints remaining.
		When the cartridge is depleted, the Color cartridge light glows red. Install a new cartridge (see Installing and removing the color cartridge). After installing a new color cartridge, press the Print button, , to clear the cartridge error and resume printing.

Previous Next