Kodak EasyShare C875 zoom digital camera — User's guide

Camera does not turn on

• Remove battery and verify that it's the correct type, then reinsert it.

• Insert a new or charged battery.

• Connect the camera to a Kodak 3-volt AC adapter (sold separately), then try again. See Battery safety and handling.

Camera does not turn off and the lens does not retract

Camera buttons and controls do not function

Lens does not extend when camera turns on or does not retract

• Confirm that the battery in camera is charged.

• Turn camera off, then on again. (Lens does not extend in Favorites mode.)

• If problem still exists, get help (Getting help).

In Review, a blue or black screen is displayed instead of a picture

• Transfer the picture to the computer.

• Transfer all pictures to the computer (Transferring pictures).

• Take another picture. If problem continues, try internal memory and/or another memory card.

Picture orientation is not accurate

• Set the Orientation Sensor to ON (see ).

Pictures remaining number does not decrease after taking a picture

• Continue taking pictures. The camera is operating normally.

(The camera estimates the number of pictures remaining after each picture is taken, based on picture size and content.)

Flash does not fire

• Check the flash setting and change as needed (Using the flash ).

  NOTE:

  The flash does not fire in all modes.

  
  

Storage location is almost or entirely full

• Transfer pictures to the computer (Transferring pictures). Delete pictures from the card (Deleting pictures and videos during review) or insert a new card.

• Change image storage location to internal memory ().

Battery life is short

• Make sure the correct battery type is installed (Loading the battery).

• Wipe the contacts with a clean, dry cloth before inserting a battery in the camera.

• Insert a new or charged battery.

You cannot take a picture

• Turn the camera off, then on again. Make sure the camera is not in Favorites mode.

• Depress shutter button all the way (Taking a picture).

• Insert a new or charged battery (Loading the battery).

• Wait until the Ready light turns green before attempting to take another picture.

• Memory full. Transfer pictures to the computer (Transferring pictures), delete pictures (Deleting pictures and videos during review), change image storage location (), or insert another card.

Error message appears on LCD

• Turn the camera off, then on again.

• Remove memory card from the camera.

• Remove the battery and wipe the contacts with a clean, dry cloth.

• Insert a new or charged battery (Loading the battery).

• If problem still exists, get help (Getting help).

Memory card not recognized or camera freezes with card.

• Card may be corrupted. Format card in camera (see ).

• Use another memory card.