Kodak EasyShare G610 printer dock — User's guide


Table of Contents > Setting up your digital camera > Docking and charging the camera

2 Setting up your digital camera

Docking and charging the camera

Docking your digital camera lets you make prints directly from the camera, transfer pictures from the camera to the computer, and charge the camera battery.

This printer dock is ImageLink print-system compatible. You can dock not only Kodak EasyShare digital cameras, but other brands of ImageLink system-compatible digital devices.

NOTE: Not all cameras are compatible for charging on the G610 printer dock. See your camera user's guide for dock compatibility.

Docking the camera


  1. Connect your printer dock power (see Connecting the power) and attach a custom camera insert (see Attaching the custom camera insert).

  2. Load a Kodak Ni-MH rechargeable digital camera battery KAA2HR, or a Kodak Li-Ion rechargeable digital camera battery into the camera for charging. See your camera user's guide.

NOTE: Your printer dock charges only Kodak Ni-MH KAA2HR and Li-Ion rechargeable batteries.

  3. Place the camera on the printer dock. Push camera down to seat the connector.

The battery status light on the printer dock lights up if a rechargeable battery is in the camera, and an initializing message appears on the camera screen.

Keep the camera strap clear of the paper path to the front and rear of the printer dock.

The camera is now powered by the printer dock instead of the camera battery.

Charging the camera

  • Make sure your printer dock power is connected (see Connecting the power), and your camera is docked (see Docking the camera).

  • The Kodak Ni-MH rechargeable digital camera battery or Kodak Li-Ion rechargeable digital camera battery in your camera charges up to 3 hours.

  • You may leave the camera on the printer dock to maintain the charge.

NOTE: Charging does not begin immediately after the camera is docked. It may take several minutes before the battery light indicates the charge status.

For Kodak EasyShare camera and dock compatibility, visit www.kodak.com/go/adapterkitchart.

Refreshing the Kodak Ni-MH rechargeable camera battery

IMPORTANT: The battery refresh feature is intended for use with the Kodak Ni-MH rechargeable digital camera battery KAA2HR only. Li-Ion batteries do not require refreshing.

NOTE: If you are getting fewer than 20 pictures per charge, you may need to refresh the battery. The refresh cycle completely discharges the battery, then fully charges it. See Extending battery life, Extending battery life.

  1. Make sure the Ni-MH rechargeable battery is in the camera.

  2. Place your EasyShare camera on the printer dock (see Docking the camera).

  3. Press and hold the and Cancel buttons on the printer dock at the same time for 5 seconds, then release the buttons.

To purchase a Kodak Ni-MH rechargeable digital camera battery for your digital camera, visit www.kodak.com/go/accessories. See your camera user's guide for battery compatibility.



Previous Next