Kodak ESP 7 All-in-One Printer — User Guide


Table of Contents > Scanning > Adjusting scan settings

7 Scanning

Adjusting scan settings

You can change the default scan settings for your printer using the control panel. When you change scan settings from the control panel, the settings apply only to the current scan job. To apply scan settings to all future scan jobs, you can save your changes.

  1. From the control panel, press Menu.

  2. Press until Scan is selected.

  3. Press OK to display the Scan Options menu. A sample of the menu is shown in the illustration below.



  4. Here you can press until the option you want to adjust is selected. If a value is displayed between the and symbols in the row, press or to select the value you want.

  5. Any changes you make to the scan settings apply only to the current scan operation. To keep the settings as permanent, press until Save as Defaults is selected, and then press OK.

  6. Press Start to initiate the scan.

The available scan settings are in the following table:



Previous Next