KODAK EASYSHARE Digital Frame — P725/P825

Table of Contents > Doing more with your frame > Upgrading your firmware (recommended)

3 Doing more with your frame

Firmware is the software that runs on your frame. Download and install the latest version from the Web to keep your frame up to date.

Turn your frame on. Press the Power and the Next buttons at the same time and hold for 5 seconds. Note the firmware version listed on the About screen.

On your computer, go to www.kodak.com/go/digitalframedownloads.
Enter your frame model and note the firmware version that's available for download. If it's newer than the version on your frame, continue with these download and upgrade directions.
Follow the screen directions to download the frame firmware to your computer.
When the firmware is downloaded, copy the IMG file to the root directory (top level, not in a folder or subfolder) of a memory card or USB flash drive.

Remove the memory card or USB flash drive from your computer, then insert it into the frame.
The Install Firmware screen appears on your frame. This screen only appears when the firmware upgrade file (IMG) is present on the card or device.

Highlight the newer firmware version, then press OK to begin the upgrade.

IMPORTANT:

Do not turn off the frame or remove the memory card or USB flash drive during the upgrade!

When the upgrade is complete, your frame automatically restarts. If it doesn't, turn the frame off, then back on.

Previous Next