Kodak ESP 5 All-in-One Printer — User Guide

Table of Contents > Scanning > Adjusting scan settings

---

6 Scanning

Adjusting scan settings

You can change the factory default scan settings for your printer using the control panel. When you change scan settings from the control panel, the settings apply only to the current scan job. To apply scan settings to all future scan jobs, you can save your changes.

1. Press Menu to display the main menu

2. Press until Scan is selected.

3. Press OK to display the Scan menu.

4. As needed, press to change the scan settings for Scan What and Scan To.

   NOTE:

   Any changes you make to the scan settings apply only to the current scan operation.

   
   

5. To keep the settings as permanent, press until Save as Defaults is selected, and then press OK.

6. Press Start to initiate the scan.

Previous Next