KODAK EASYSHARE M575 Digital Camera — User guide
Table of Contents > Product Overview
Attach the strap, load the battery
Charge the battery
Charge the battery whenever necessary.
Turn on the camera
Set the language and date/time
See the Extended user guide |
Take a picture
See other modes |
|
See the Extended user guide |
Review pictures/videos
See the Extended user guide |
Download software, transfer pictures
When you connect the camera to the computer, it prompts you to run the KODAK Software Downloader on your computer.
Make sure the computer is connected to the Internet. When you connect the camera to the computer, the KODAK Software Downloader automatically runs. Follow the prompts to download and install KODAK Software.
|
1.
Turn off the camera.
|
||
2.
Use the KODAK Camera USB Cable, Micro B / 5-Pin to connect camera to computer. (Use only the cable included with this camera!)
|
|||
3.
Turn on the camera.
|
|||
4.
After the software is installed, follow the prompts to transfer pictures and videos to your computer.
|
NOTE: | If the downloader does not run, find it here and launch it:
|
Download KODAK Software |
|
To use this camera on more than one computer |
See the Extended user guide at www.kodak.com/go/m575support |
Use the camera Help system
Keep learning about your camera!
See the Extended user guide |
Front View
Back View
Previous Next