KODAK ESP 7200 Series All-in-One Printer — Extended User Guide
Table of Contents > Copying > Copying a photograph
5 Copying
Copying a photograph
You can copy a photograph using the default settings, or you can make adjustments to the quantity, size, quality, and brightness of your copies. When you copy a photograph, the printer will use paper from the top paper tray, unless you specify otherwise.
Using the default settings to copy a photograph
The default settings are either the factory default settings (Resetting factory defaults), or defaults that you have set on the printer ().
To copy a photograph using the current default settings:
-
Lift the scanner lid, and place the photograph face down in the right-front corner of the scanner glass.
-
Close the lid.
-
Press Home.
-
Press to select Copy Photo.
-
Press Start to begin copying.
Adjusting the settings and copying a photograph
To copy a photograph using settings other than the default settings:
-
Lift the scanner lid, and place the photograph face down in the right-front corner of the scanner glass.
-
Close the lid.
-
Press Home.
-
Press to select Copy Photo, then press OK.
-
Press to select an option, then press or to change the setting.
-
Changing the number of copies of a photograph
To change the number of copies:
-
Lift the scanner lid, and place the photograph face down in the right-front corner of the scanner glass.
-
Close the lid.
-
Press Home.
-
Press to select Copy Photo, then press OK.
-
Make sure Quantity is selected.
-
Press or to select a number.
-
Press Start to begin copying.
Enlarging or reducing a photograph
To enlarge or reduce the size of the copy:
-
Lift the scanner lid, and place the photograph face down in the right-front corner of the scanner glass.
-
Close the lid.
-
Press Home.
-
Press to select Copy Photo, then press OK.
-
Press to select Copy Size.
-
Press or to select the copy size.
NOTE: If you select a copy size larger than 5 x 7 in. / 13 x 18 cm, press to select Tray Selection, then press to select Bottom Tray. Make sure that the paper in the bottom tray is the size and type (plain paper, photo paper, etc.) that you want.
-
Press Start to begin copying.
Darkening or lightening a copy of a photograph
To darken or lighten the copy:
-
Lift the scanner lid, and place the photograph face down in the right-front corner of the scanner glass.
-
Close the lid.
-
Press Home.
-
Press to select Copy Photo, then press OK.
-
Press to select a number below zero for a darker copy, or press to select a number above zero for a lighter copy.
Previous Next