KODAK ESP 9200 Series All-in-One Printer — Extended User Guide
Table of Contents > Handling Paper > Loading paper
3 Handling Paper
Loading paper
Loading plain paper in the main paper tray
The main paper tray capacity is 100 sheets of plain paper.
To load plain paper:
-
Raise the output tray, and pull out the paper tray.
-
Move the left paper-edge guide to the far left.
-
Move the front paper-edge guide forward.
-
Fan and stack the paper, then insert it into the tray.
-
Move the paper forward until it stops.
-
Move both the left and front paper-edge guides until they touch the paper.
-
Push in the paper tray until it clicks into place, and lower the output tray.
-
Pull out the output tray extender until it is fully extended.
-
NOTE: You may also load photo paper as small as 4 x 6 in. / 10 x 15 cm in the main paper tray with the logo side facing up and the glossy side down.
Loading legal-size paper in the main paper tray
The main (bottom) paper tray capacity is 100 sheets of legal-size (8.5 x 14 in. / 22 x 36 cm) paper.
To load legal-size paper:
-
Raise the output tray, and pull out the main paper tray.
-
Move the left paper-edge guide to the far left.
-
Move the front paper-edge guide forward.
-
Press the paper tray extender, and pull the paper tray forward until it is fully extended.
-
Fan and stack the paper, then insert it into the tray.
-
Move the paper forward until it stops.
-
Move both the left and front paper-edge guides until they touch the paper.
-
Push in the main paper tray until it clicks into place, and lower the output tray.
-
Pull out the output tray extender until it is fully extended, but do not lift the paper stop.
NOTE: To close the paper tray extender, pull out the main paper tray and take out the legal-size paper. Press the paper tray extender and push the tray forward until you hear a click.
Loading the photo paper tray
The photo (top) paper tray capacity is 40 sheets of photo paper.
To load photo paper:
-
Raise the output tray, and pull out the photo paper tray.
-
Move the left paper-edge guide to the far left.
-
Move the front paper-edge guide forward.
-
Fan and stack the photo paper, then insert it (short side first) into the tray with the logo side facing up and the glossy side down.
IMPORTANT: If the photo paper is loaded the wrong way, the ink on your pictures will be wet and the image quality will be affected.
-
Move the paper forward until it stops.
-
Move both the left and front paper-edge guides until they touch the paper.
-
Push in the photo paper tray until it clicks into place, and lower the output tray.
Loading envelopes
The main paper tray capacity is 20 envelopes.
IMPORTANT: | Do not load envelopes with cutout or clear windows. |
To load envelopes:
-
Raise the output tray, and pull out the main paper tray.
-
Remove any paper from the tray.
-
Make sure the left paper-edge guide is to the far left.
-
Move the front paper-edge guide forward.
-
Insert the envelopes into the tray with the flap up and against the right side of the tray.
-
Move the envelopes forward until they stop.
-
Move both the left and front paper-edge guides until they touch the envelopes.
-
Push in the main paper tray until it clicks into place, and lower the output tray.
Previous Next