KODAK PLAYSPORT Video Camera / Zx5 — Extended user guide

Table of Contents > Appendix > Care and maintenance

4 Appendix

Before inserting or removing the card, make sure your hands, the camera, and the card are completely dry.
In water, do not use below a depth of 3 meters (9.8 ft).
Do not open/close camera doors in water.
The camera will not float. Use the strap at all times.
If water has entered the camera, remove the card. Allow all components to air-dry for at least 24 hours before using the camera.
If the camera was used in chemically treated water or saltwater, rinse it in fresh water, then use a soft towel to dry it.
Wipe off dirt or sand from the door seals—debris could compromise the seal and cause a leak when in water.
Do not subject the camera to temperatures lower than 0 (32°F) or higher than 40°C (104°F) for an extended time—the integrity of the seals may be compromised. Wait until camera reaches operating temperatures before using.
Blow gently on the lens or LCD to remove dust and dirt. Wipe gently with a soft, lint-free cloth or an untreated lens-cleaning tissue. Do not use cleaning solutions unless designed specifically for camera lenses. Do not allow chemicals, such as suntan lotion, to contact painted surfaces.
Service agreements may be available in your country. Contact a dealer of KODAK Products for more information.
For camera disposal or recycling information, contact your local authorities. In the US, go to the Electronics Industry Alliance Web site at www.eiae.org or go to Kodak at www.kodak.com/go/support.

Previous Next