KODAK OFFICE HERO 6.1 All-in-One Printer — Extended User Guide


Table of Contents > Handling Paper > Loading paper

4 Handling Paper

Loading paper

Loading plain paper

The capacity of the paper tray is 200 sheets of plain paper.

  1. Raise the output tray, and pull out the paper tray.



  2. Make sure the left paper-edge guide is to the far left.

  3. Move the front paper-edge guide forward.



    NOTE: When loading legal-size (8.5 x 14 in. / 22 x 36 cm) paper, move the front paper-edge guide forward until it is fully extended.



  4. Fan and stack the paper, then insert it into the tray.

  5. Move the paper forward until it stops.

  6. Move both the left and front paper-edge guides until they touch the paper.



  7. Push in the paper tray until it clicks into place, and lower the output tray.



  8. Pull out the output tray extender until it is fully extended.

  9. Lift the paper stop.



    NOTE: When loading legal-size (8.5 x 14 in. / 22 x 36 cm) paper, move, do not lift the paper stop.

Loading photo paper

The capacity of the paper input tray is 70 sheets of photo paper.

  1. Raise the output tray, and pull out the paper tray.



  2. Remove any paper from the tray.

  3. Insert the photo paper (short side first) into the tray with the logo side facing up and the glossy side down.

    IMPORTANT: Always load the paper short side first . The printer automatically detects the orientation of the picture, whether it's portrait or landscape, and prints accordingly. If the photo paper is loaded in the wrong direction, the image will be cut off and the paper may jam. If the paper is loaded with the wrong side up, the image quality will be affected.

  4. Move the paper forward until it stops.

  5. Move both the left and front paper-edge guides until they touch the paper.



  6. Push in the paper tray until it clicks into place, and lower the output tray.

Loading envelopes

It is best to load envelopes one at a time.

IMPORTANT: Do not load envelopes with cutout or clear windows.

To load envelopes:

  1. Raise the output tray, and pull out the paper tray.



  2. Remove any paper from the tray.

  3. Move the left paper-edge guide to the far left.

  4. Move the front paper-edge guide forward.



  5. Insert the envelope(s) into the tray with the flap up and the top of the envelope against the right side of the tray.

  6. Move both the left and front paper-edge guides until they touch the envelope(s).



  7. Push in the paper tray until it clicks into place, and lower the output tray.



  8. Pull out the output tray extender until it is fully extended

  9. Lift the paper stop.





Previous Next