KODAK OFFICE HERO 6.1 All-in-One Printer — Extended User Guide

Table of Contents > Handling Paper > Loading originals

---

4 Handling Paper

Loading originals

You can place originals for copying, scanning, or faxing on the scanner glass or in the ADF (Automatic Document Feeder). The ADF automatically feeds the originals into the printer when you begin copying, scanning, or faxing.

NOTE:

Keep the scanner glass clean. Any dirt or smudges on the glass will appear as marks on the copy. See Cleaning the scanner glass and document backing.

Using the scanner glass

To place an original on the scanner glass:

1. Remove any originals from the Automatic Document Feeder (ADF).

2. Lift the scanner lid, and place the document or picture face down in the right-front corner.

   
   
   

3. Close the scanner lid.

Using the Automatic Document Feeder (ADF)

You can load up to 35 originals (20 to 24 lb / 75 to 90 gsm plain paper) in the Automatic Document Feeder (ADF).

The ADF accepts originals in the following sizes:

	Minimum size	Maximum size
English units	6.9 x 9.8 in.	8.5 x 14 in.
Metric units	176 x 250 mm	216 x 356 mm

IMPORTANT:

Do not load photographs, cards, or any paper stock heavier than 24 lb / 90 gsm or lighter than 16 lb / 60 gsm in the ADF.

1. Remove any originals from the scanner glass.

2. Open the ADF paper tray, and move the ADF paper-edge guides outward.

   
   
   

3. Fan and stack the originals, then insert them face up in the ADF, with the top of the pages in first.

   IMPORTANT:

   Remove all paper clips and staples from the originals.

   
   
   
   

4. Move the ADF paper-edge guides until they touch the paper.

The ADF automatically feeds the originals into the printer when you begin copying, scanning, or faxing .

Previous Next