KODAK HERO 5.1 All-in-One Printer — Extended User Guide


Table of Contents > Troubleshooting > Status lights

10 Troubleshooting

Status lights

The status lights indicate the condition of the printer. There are two status lights on the printer, one that indicates power, the other indicates Wi-Fi status.

Power status light

Power light What it means

Off

The printer is turned off.

  • Press the power button to turn on power.

The printer does not have power.

  • Make sure that the power cord is plugged into the back of the printer and into an electrical outlet, and that the electrical outlet has power.

Blinking

The printer is busy.

  • Wait for the printer to finish the task.

On

The printer is ready.

Wi-Fi status light

Power light What it means

Off

The Wi-Fi radio is either turned off, or is turned on but not connected to a wireless network.

Blinks continuously

The Wi-Fi radio is turned on and the printer is searching for available wireless networks within range.

Blinks intermittently

The Wi-Fi radio is turned on and the printer cannot find any available wireless networks within range, or the Wi-Fi radio connection has been interrupted, or is too weak to send signals to and from the printer

To find and connect to an available wireless network within range, press OK , turn the Wi-Fi radio off, and run the Wi-Fi Setup Wizard (see Connecting to a wireless network).

On

The Wi-Fi radio is turned on and there is a working connection between the printer and a wireless network.



Previous Next