KODAK EASYSHARE Camera / Z5120 — Extended user guide
Table of Contents > Installing, setting up software > Installing the Share Button App
2 Installing, setting up software
Installing the Share Button App
| IMPORTANT: | Until you install and set up the Share Button App, the camera Share button is not enabled. |
|
|
|
|
|
1.
Make sure the computer is connected to the Internet.
|
|||
|
2.
Turn off the camera.
|
|||
|
3.
Using the USB cable, connect the camera to a computer USB port. Then turn on the camera.
The Camera Setup App runs. (If there are many pictures on your memory card, this step could take several minutes.) |
||
|
4.
Watch your computer—when the Camera Setup App prompts you to install the Share Button App, click Install Now. (If you are prompted to allow the Camera Setup App to run, click Allow.)
|
|||
|
5.
When prompted, click Finish.
|
|||
If you successfully installed the software Setting up the Share Button App (one-time setup)
If software installation does not begin after several minutes
-
Make sure the computer is connected to the Internet.
-
Open My Computer. (For MAC OS, go to the Finder.)
-
Open the KODAK Setup App. (For MAC OS, open the KODAK Camera Setup App.)
If the installation still doesn't begin
-
Download the Share Button App from www.kodak.com/go/camerasw.
-
After it's downloaded, double-click to install it.
Previous Next