KODAK HERO 9.1 All-in-One Printer — Extended User Guide
Table of Contents > Networking Your Printer > Connecting to an Ethernet network
2 Networking Your Printer
Connecting to an Ethernet network
Before you connect, you need:
-
an Ethernet network that includes a router, switch, or hub with an Ethernet port.
-
a Category 5 (or higher) Ethernet cable.
-
to temporarily disable your firewall until the printer is successfully installed and communicating.
To connect to an Ethernet network:
-
Connect the Ethernet cable to the Ethernet port on the back of the printer.
-
Connect the other end of the Ethernet cable to an available Ethernet port on your router, switch, or hub.
-
If you haven't installed the KODAK All-in-One Printer Software:
-
In the results list, click the link for KODAK All-in-One Software for your computer's operating system.
-
Follow the on-screen instructions.
Previous Next