KODAK EASYSHARE CX4200 Digital Camera — User's Guide


Table of Contents > Using the KODAK EASYSHARE Camera Dock II > Connecting the Camera Dock

8 Using the KODAK EASYSHARE Camera Dock II

Connecting the Camera Dock

After the KODAK EASYSHARE Software is loaded (see Install the Software), connect the Camera Dock to your computer and to an external power source. You will need:

  • the USB cable included with your camera

  • the AC adapter, 7-Volt included with the Camera Dock

IMPORTANT: Make sure your camera is NOT in the Camera Dock when you are connecting to power and the computer.


  1. Plug the labeled ( ) end of the USB cable into the labeled USB port on your computer.

See your computer User's Guide for details.

  2. Plug the other end of the USB cable into the square USB connector on the back of the Camera Dock.

  3. Plug the AC adapter into the round power connector on the back of the Camera Dock and into a power outlet.

Your AC adapter may be different from the one pictured or may have additional plugs. Use the plug that accommodates your type of power outlet.

Leave the Camera Dock connected to the computer for easy access for transferring pictures and charging the Battery Pack.

IMPORTANT: Use only the AC adapter, 7-Volt included with the Camera Dock. Other adapters may cause damage to your camera, Camera Dock, or computer.



Previous Next