Kodak EasyShare DX6340 zoom digital camera — User's Guide
Table of Contents > Using the Camera Dock 6000 > Connecting the Camera Dock 6000
9 Using the Camera Dock 6000
Connecting the Camera Dock 6000
After the Kodak EasyShare software is loaded (see Install the Software), connect the camera dock to your computer and to a power outlet. You need:
-
The USB cable included with your camera
-
The AC adapter, 5-volt included with the camera dock
IMPORTANT: | Make sure your camera is NOT in the camera dock when you are connecting to power and the computer. |
|
1.
Plug the labeled end of the USB cable into the labeled USB port on your computer.
See your computer user's guide for details. |
||
2.
Plug the other end of the USB cable into the square USB connector on the back of the camera dock.
|
|||
3.
Plug the AC adapter into the round power connector on the back of the camera dock and into a power outlet.
Your AC adapter may differ from the one pictured or may have additional plugs. Use the plug that accommodates your type of power outlet. |
IMPORTANT: | Use only the AC adapter, 5-volt included with the camera dock 6000. Other adapters may cause damage to your camera, camera dock, or AC adapter. |
Leave the camera dock connected so it's always ready to transfer pictures and videos.
Previous Next