Kodak EasyShare DX6340 zoom digital camera — User's Guide
Table of Contents > Using the Camera Dock 6000 > Charging the Battery
9 Using the Camera Dock 6000
Charging the Battery
|
1.
Make sure the Kodak EasyShare Ni-MH rechargeable battery pack is installed in the camera (see Installing the Rechargeable Battery).
|
||
2.
Turn off the camera and place it in the camera dock (see Docking the Camera).
If the battery requires charging, charging begins after a brief battery check. |
-
Full charging takes about 2.5 hours.
-
Charging stops if you turn on the camera. If the camera is left in the camera dock with the power on, charging resumes when the camera enters auto power-off (see Power-Saving Features).
-
Charging is suspended during picture transfer.
Charging Lights Status
Charging Lights |
Cause |
Green lights
|
Camera is properly docked. Battery is either being checked or is less than half charged. Battery is more than half charged. Battery is fully charged. |
Red light (blinking)
|
Battery is not properly installed (see Installing the Rechargeable Battery). Battery or connector pin is damaged. Camera and battery have been exposed to extreme temperatures. Slowly return to room temperature. |
No lights |
Camera is not properly seated in the camera dock. AC adapter is not connected. Correct battery is not installed (see Installing the Rechargeable Battery). |
Previous Next