Kodak EasyShare CX6200 digital camera — User's Guide

Table of Contents > Using the Camera Dock 6000 > Installing the Custom Camera Insert

---

9 Using the Camera Dock 6000

Installing the Custom Camera Insert

A universal insert is pre-installed in the camera dock. It allows all Kodak EasyShare CX/DX6000 series and LS600 series cameras to use the camera dock.

A custom insert is included with your camera. It provides a perfect fit for your Kodak EasyShare CX6200 digital camera.

Remove the Universal Insert

		1. Place your thumbs in the indents in the front of the universal insert; press in and lift.
		2. Lift the insert at the side edge and remove the insert from the dock.
		3. Save the universal insert as a spare.

Install the Custom Insert

		1. Position the custom insert so the cutout lines up with the connector on the camera dock.
		2. Fit the insert into the groove in the dock and snap it into place. You can purchase a custom insert for your camera at dealer of Kodak products. See www.kodak.com/go/cx6200accessories.

Previous Next