Kodak EasyShare printer dock 4000 — User's Guide


Table of Contents > Getting Started with Your Printer Dock > Installing the Camera Insert

1 Getting Started with Your Printer Dock

Installing the Camera Insert

The printer dock comes with a universal camera insert installed, which is used to fit the camera to the printer dock. The universal insert is used with most cameras.

If your camera comes with a custom insert, use that one instead of the universal insert. Do not discard the universal insert.


  1. To remove the universal insert:

  1. Push the insert towards the front of the printer and lift the back edge.

  2. Push the insert towards the rear of the printer and lift out the front edge.


  2. To install the custom insert (included with your camera).

  1. Place the front tabs on the insert in the slots in the front of the printer dock.

  2. Fit the back of the insert down into the dock and snap the insert into place.



Previous Next