Kodak EasyShare LS753 zoom digital camera — User's guide
Table of Contents >
Troubleshooting > Picture quality problems
7 Troubleshooting
|
If...
|
Try one or more of the following
|
|
The picture is too dark or underexposed
|
-
Use Fill flash () or change your position so light is not behind the subject.
-
Move so that the distance between you and the subject is within the effective flash range (see ).
-
To automatically set exposure and focus, press the Shutter button halfway and hold. When the ready light glows green, press the Shutter button completely down to take the picture.
-
Increase Exposure Compensation () and try again.
|
|
The picture is too light
|
-
Turn flash off ().
-
Move so that the distance between you and the subject is within the effective flash range (see ).
-
To automatically set exposure and focus, press the Shutter button halfway and hold. When the ready light glows green, press the Shutter button completely down to take the picture.
-
Decrease Exposure Compensation () and try again.
-
Check if you are in Beach or Snow scene mode ().
|
|
The picture is not clear
|
-
To automatically set exposure and focus, press the Shutter button halfway and hold. When the ready light glows green, gently press the Shutter button completely down to take the picture.
-
Clean the lens (Tips, safety, maintenance).
-
Make sure camera is not in Close-up mode if you are further than 39 in. (100 cm) from your subject.
-
Place the camera on a flat, steady surface or use a tripod.
|
Previous
Next