Kodak EasyShare printer dock plus — User's Guide


Table of Contents > Getting started > Installing the custom camera insert

1 Getting started

Installing the custom camera insert

The Kodak EasyShare printer dock plus comes with a universal camera insert already installed. The insert allows most Kodak EasyShare CX/DX6000/7000 series and LS600 series digital cameras to fit on the printer dock.

For best fit, use the custom camera insert that came with your camera and keep the universal camera insert as a spare.

NOTE: For some cameras, including LS700 series, you must use the custom camera insert to dock the camera, otherwise the camera will not fit on the printer dock.


  1. Remove the universal camera insert:

  1. Push the insert toward the back of the printer dock and lift up the front edge.

  2. Lift up the back edge of the insert and remove.


  2. Install the custom camera insert included with your camera:

  1. Place the rear tabs of the insert in the slots toward the back of the printer dock.

  2. Press the front of the insert down and snap into place.



Previous Next