Kodak EasyShare printer dock plus — User's Guide

Table of Contents > Getting started > Loading the paper

---

1 Getting started

Loading the paper

IMPORTANT:

Use only Kodak color cartridge & paper kits for your printer dock. Do not use inkjet paper.

1. Remove the paper tray from the printer dock if installed (see Installing and removing the paper tray).
		2. Slide the paper tray cover back until it "clicks" into place, about 1.25 in. (3 cm), then lift up on the end of the paper tray cover. IMPORTANT: Do not load more than 25 sheets of paper. Use the upper limit line inside the paper tray as a guide to prevent overloading. Do not load paper that is missing perforated tabs. To avoid fingerprints, do not touch the glossy side of the paper.
		3. Carefully "fan" the paper to keep the sheets from sticking together.
		4. Load the paper into the paper tray, with the Kodak logo side facing down.
		5. Close the paper tray cover.

Purchase Kodak color cartridge & paper kits and other accessories at a retailer of Kodak products, or visit www.kodak.com/go/accessories.

Previous Next