Kodak EasyShare printer dock plus — User's Guide
Table of Contents > Printing without a computer > Enhancing your pictures
3 Printing without a computer
Enhancing your pictures
Use Auto-Enhance to automatically enhance over- or underexposed pictures.
To apply Auto-Enhance to a print job:
-
When setting up a print job, press the Auto-Enhance button, before pressing the Print button.
The Auto-Enhance light glows steady, then blinks during printing.
To change the default so Auto-Enhance is always on:
-
Press and hold the Auto-Enhance button, for 5 seconds.
The Auto-Enhance light blinks, then glows steady.
Repeat the above step to return the Auto-Enhance default setting to off.
NOTE: | The Auto-Enhance button is not enabled when printing from a computer. If printing from a computer (see Printing from a computer), use the Kodak EasyShare software on your computer.
Printing time may slightly increase when using Auto-Enhance. |
Previous Next