Kodak EasyShare photo printer 500 — User's Guide


Table of Contents > Appendix > Additional care and maintenance

8 Appendix

Additional care and maintenance

  • Do not allow chemicals, such as suntan lotion, to come into contact with the painted surface of the photo printer.

  • If the photo printer has been subjected to inclement weather or you suspect water has gotten inside the photo printer, turn off the photo printer and remove the paper tray and color cartridge. Allow all components to air-dry for at least 24 hours before using the photo printer again. If this does not resolve the problem, contact customer support (see Telephone customer support).

  • Connect a tripod directly to the camera; do not connect a tripod to the printer.

  • Service agreements are available in some countries. Contact a dealer of Kodak products for more information.

  • The photo printer and the AC power adapter contain a small amount of lead in the circuit board. Disposal of this material may be regulated due to environmental considerations.

    Disposal of the color cartridge is not regulated and should not be subject to state or local landfill, incineration, or recycling requirements.

    For more disposal or recycling information, contact your local authorities. In the US, visit the Electronics Industry Alliance Web site at www.eiae.org.



Previous Next