Kodak EasyShare-One zoom digital camera — User's guide


Table of Contents > Troubleshooting > Printing

9 Troubleshooting

Printing

Problem Possible causes and/or solutions

Printing does not start

NOTE: The EasyShare-One camera is not PictBridge compatible. As such, a USB connection to Kodak EasyShare printer docks and photo printers is not supported. However, you can dock the camera on an EasyShare printer dock (see Dock compatibility), or print remotely to a Wi-Fi enabled EasyShare printer.

  • The printer power is off.

  • The printer is busy printing or is engaged in another session, or has a full buffer.

  • The printer is in an error state. Correct the error.

  • The IP address setting on the camera or printer is incorrect. Change the IP address or set to Dynamic IP.

  • If printing directly to a Wi-Fi enabled EasyShare printer, check to make sure the printer, camera, and computer (if using one) network settings match.

    Check for other problems with the wireless network (see Wireless network connection).

Printing stops or is not complete

  • The printer was disconnected from the camera, computer, or network in mid-print.

Camera prints to the wrong Wi-Fi enabled printer

  • The selected printer has the same name as the intended one, and is on the same network. Change the name of one of the printers using the printer configuration utility. See the printer user's guide for details



Previous Next