Kodak EasyShare G610 printer dock — User's guide

Light is off

Camera not properly seated on connector.

Reseat the camera on the printer dock (Docking and charging the camera).

Unrecognized battery type installed, or camera does not support charging.

Install a Kodak Ni-MH rechargeable digital camera battery or Kodak Li-Ion rechargeable digital camera battery. See your camera user's guide for battery compatibility and other charging options.

AC power cord not connected.

Connect the AC power cord (Connecting the power).

Light glows green

Camera just placed on printer dock.

None; dock is checking the charge status of the battery.

Battery fully charged.

None required.

Light glows amber

Battery charging.

Leave the camera on the dock to continue charging or to maintain charge.

Light blinks fast amber

Battery not properly installed.

Re-install the battery.

Battery or connector pin damaged.

Check for damage.

Battery exhausted.

Refresh the battery (Refreshing the Kodak Ni-MH rechargeable camera battery).

Light blinks slow amber

The Ni-MH battery refresh cycle in progress: discharging (light turns off as discharging progresses).

Leave the camera on the dock to continue refresh cycle (Refreshing the Kodak Ni-MH rechargeable camera battery).

Light glows green

Printer dock ready for transferring pictures.

None required.

Light blinks green

Pictures transferred to the computer.

None required.

After transferring pictures, the transfer light continues to blink green until either the camera is removed, the Transfer button is pressed again, or the connection is no longer available.

Light is off

No pictures in camera or on memory card.

None required.

Camera not docked.

To enable Transfer:

1. Connect printer dock to computer (Connecting to a computer).

2. Take pictures.

3. Dock the camera.

Printer dock not connected to computer.

Camera not properly seated on connector.

Reseat the camera on the printer dock (Docking and charging the camera).

Computer off.

Turn on the computer.