Kodak ESP 9 All-in-One Printer — User Guide
Table of Contents > Maintaining Your Printer > Upgrading the printer software - for Macintosh
9 Maintaining Your Printer
Upgrading the printer software - for Macintosh
You can upgrade the software and firmware for your All-in-One printer with the most recent release available. This requires an Internet connection.
NOTE: | The firmware cannot be upgraded when your All-in-One printer is connected via a network or Wi-Fi. Your All-in-One printer must be connected to the computer with a USB cable in order to perform a firmware upgrade. |
-
If your connection is via Ethernet, disconnect the Ethernet cable. If your connection is via Wi-Fi, press Menu. Navigate to Network Settings menu and press OK. Select WIFI Radio off.
-
Connect the printer to the computer with a USB cable. The computer must be connected to the internet.
-
Open a browser window and enter the following URL: http://www.kodak.com/go/aiosupport.
-
Select your printer model.
-
Under Downloads, select Software Driver and Firmware Downloads.
-
Select your operating system from the drop down list.
-
Download the software.
-
Double-click on the *.dmg file.
-
Double-click on Install Software.
-
Follow the on-screen prompts on the installer.
-
Upon completion of the install, click Restart. The Home Center software and the printer and scanner drivers are updated.
-
Next you will update printer firmware.
-
Open a browser window and enter the following URL: http://www.kodak.com/go/aiosupport.
-
Select your printer model.
-
Under Downloads, select Software Driver and Firmware Downloads.
-
Select your operating system from the drop down list.
-
Download the firmware.
-
Double-click on the *.dmg file.
-
Double-click on Kodak AiO Updater.
-
Upon completion of the install, click Quit. The printer firmware is updated.
Previous Next