KODAK EASYSHARE SPORT Camera / C123 — Extended user guide
Table of Contents > Appendix > Care and maintenance
8 Appendix
Care and maintenance
-
If you suspect water has gotten inside the camera, remove the batteries and card. Allow all components to air-dry for at least 24 hours before using the camera.
-
Blow gently on the lens or LCD to remove dust and dirt. Wipe gently with a soft, lint-free cloth or an untreated lens-cleaning tissue. Do not use cleaning solutions unless designed specifically for camera lenses. Do not allow chemicals, such as suntan lotion, to contact painted surfaces.
-
Service agreements may be available in your country. Contact a dealer of KODAK Products for more information.
-
For digital camera disposal or recycling information, contact your local authorities. In the US, go to the Electronics Industry Alliance site at www.eiae.org or Kodak at www.kodak.com/go/c123support.
-
In water, do not use below a depth of 3 meters (9.8 ft).
-
Do not open/close camera doors in water.
-
The camera will not float. Use the strap at all times.
-
If water has entered the camera, remove the card. Allow all components to air-dry for at least 24 hours before using the camera.
-
If the camera was used in chemically treated water or saltwater, rinse it in fresh water, then use a soft towel to dry it.
-
Wipe off dirt or sand from the door seals—debris could compromise the seal and cause a leak when in water.
Previous Next