KODAK EASYSHARE Camera / Z5120 — Extended user guide
Table of Contents > Using an Eye-Fi Card > Storing pictures on an Eye-Fi Card
11 Using an Eye-Fi Card
Storing pictures on an Eye-Fi Card
To set up and use the Eye-Fi Card and Eye-Fi Center Software, follow the documentation that accompanies the card. For further Eye-Fi support, see Sharing pictures using an Eye-Fi Card .
|
CAUTION: If you're using an Eye-Fi Card in this camera, it's critical that you disable (do not turn on) Endless Memory Mode in Eye-Fi Center Software. |
-
Turn off the camera, then open the door.
-
Insert a card until it clicks into place.
To remove a card, press and release it.
NOTE: When you turn on the camera, it checks to see if a card is inserted. If pictures/videos are detected in internal memory, the camera prompts you to move them to the card. New pictures/videos are stored on the card.
|
Purchase Eye-Fi cards |
|
|
Get support for Eye-Fi Cards and Software |
Previous Next