Kodak EasyShare printer dock 6000 — User's Guide


Table of Contents > Getting Started with Your Camera > Docking and Charging the Camera

2 Getting Started with Your Camera

Docking and Charging the Camera

Docking your camera lets you make prints directly from the camera, transfer pictures from the camera to the computer, and charge the camera battery.

  1. Make sure the battery is installed in the camera. See your camera user's guide for details.


  2. On the camera bottom, locate the connector.


  3. Place the camera in the printer dock and push down to seat the connectors.

Charging begin when camera enters auto power-off. See your camera user's guide for details.

The camera is now powered by the printer dock instead of the camera battery.


  • The Kodak EasyShare Ni-MH rechargeable battery pack and Li-Ion rechargeable batteries take 2.5 to 3.0 hours to fully charge.

  • After the battery is charged, leave the camera in the printer dock to maintain the full charge.


  • The three green charging lights monitor the charging status (see Printer Dock Status Lights).

    1. Battery is less than half charged.

    2. Battery is more than half charged.

    3. Battery is fully charged.



Previous Next