KODAK EASYSHARE CX4200 Digital Camera — User's Guide
Table of Contents > Troubleshooting > Troubleshooting—Camera Dock II
9 Troubleshooting
Troubleshooting—Camera Dock II
Camera Dock II Problems
Camera Dock | ||
---|---|---|
Problem | Cause | Solution |
Pictures are not transferred to the computer |
AC adapter or USB cable is not securely connected. |
Check the connections (Connecting the Camera Dock). |
Software is not installed. |
Install the software (Install the Software). |
|
There are too many applications running on your computer. |
Close all software applications and try again. |
|
Camera was removed from the Camera Dock during picture transfer. |
Replace the camera on the Camera Dock and press the Connect button. |
|
Connect button was not pressed. |
Press the Connect button. |
Camera Dock II Light Status
Camera Dock Power/Transfer Light | ||
---|---|---|
Light Status | Cause | Comment |
Light glows steady green |
Camera is properly seated in the Camera Dock. |
The camera and Camera Dock are operating normally. |
Light blinks green |
Pictures are being transferred to the computer. |
|
Light is off |
Camera is not properly seated in Camera Dock. |
Remove the camera and re-seat it (Docking the Camera). |
Camera Dock Error Light | ||
---|---|---|
Light Status | Cause | Comment |
One blinking red light |
Battery Pack is installed incorrectly. |
Reinstall the Battery Pack (Installing the Battery Pack in the Camera). |
The Battery Pack or connector pins are damaged. |
Check for damage. |
|
The camera and Battery Pack have been exposed to very high or low temperatures. |
Slowly return the camera and Battery Pack to room temperature. |
|
Battery in camera is not rechargeable or no Battery Pack is installed in camera. |
Install a KODAK EASYSHARE Ni-MH Rechargeable Battery Pack (Installing the Battery Pack in the Camera). |
Previous Next