Kodak EasyShare C875 zoom digital camera — User's guide
Table of Contents >
Troubleshooting > Picture quality problems
5 Troubleshooting
Status
|
Possible solution
|
Picture is not clear
|
-
To automatically set exposure and focus, press the Shutter button halfway. When the Ready light turns green, press the Shutter button completely down to take the picture.
-
Clean the lens (Additional care and maintenance).
-
Make sure camera is not in Close-up mode.
-
Place the camera on a flat, steady surface or use a tripod, especially in high-zoom settings or in low light.
|
Picture is too dark
|
-
Use Fill flash (Using the flash ) or change your position so light is not behind the subject.
-
Move so that the distance between you and the subject is within the effective flash range ().
-
To automatically set exposure and focus, press the Shutter button halfway. When the Ready light turns green, press the Shutter button completely down to take the picture.
-
Adjust exposure compensation (Using exposure compensation to adjust brightness).
|
Picture is too light
|
-
Turn off the flash (Using the flash ).
-
Move so that the distance between you and the subject is within the effective flash range ().
-
To automatically set exposure and focus, press the Shutter button halfway. When the Ready light turns green, press the Shutter button completely down to take the picture.
-
Adjust exposure compensation (Using exposure compensation to adjust brightness).
|
Previous
Next