Kodak EasyShare DX6340 zoom digital camera — User's Guide
Table of Contents > Troubleshooting > Camera Ready Light Status
10 Troubleshooting
Camera Ready Light Status
Status | Cause | Solution |
---|---|---|
Ready light does not turn on and the camera does not work.
|
Camera is not turned on. |
Turn on the camera (Turning On the Camera). |
Battery is exhausted. |
Recharge the battery (Charging the Battery) or install a new one (Using the Battery). |
|
Mode dial was on when battery was reloaded. |
Turn Mode dial off, then back on. |
|
Ready light glows steady green. |
Camera is on; ready to take a picture or video. |
Camera is operating normally. |
Shutter button is pressed halfway down. Focus and exposure are set. |
Camera is operating normally. |
|
Ready light blinks green. |
Picture is being processed and saved to the camera. |
Camera is operating normally. |
Ready light blinks yellow. |
Flash is not charged. |
Wait. Resume picture taking when the light stops blinking and turns green. |
Auto exposure or auto focus are not locked. |
Release the Shutter button and recompose the picture. |
|
Ready light blinks red.
|
Battery is low or exhausted. |
Recharge the battery (Charging the Battery) or install a new one (Using the Battery). |
Ready light glows steady red. |
Camera's internal memory or card is full. |
Transfer pictures to the computer (Transferring Pictures With the USB Cable), delete pictures from the camera (Deleting Pictures and Videos), switch storage locations (Choosing Internal Memory or MMC/SD Card), or insert a card with available memory (Inserting an MMC/SD Card). |
Camera processing memory is full. |
Wait. Resume picture taking when the light turns green. |
|
Card is read-only. |
Change storage location to internal memory (Choosing Internal Memory or MMC/SD Card), or use a different card. |
Previous Next