Kodak EasyShare C340 zoom digital camera — User's guide
Table of Contents >
Troubleshooting > Picture quality problems
5 Troubleshooting
If...
|
Try one or more of the following
|
Picture is too dark or underexposed
|
-
Use Fill flash (
) or change your position so light is not behind the subject.
-
Move so that the distance between you and the subject is within the effective flash range (Using the flash ).
-
To automatically set exposure and focus, press the Shutter button halfway. When the Ready light glows green, press the Shutter button completely down to take the picture.
-
Adjust the exposure compensation (
).
|
Picture is too light
|
-
Turn flash off (Changing the flash settings).
-
Move so that the distance between you and the subject is within the effective flash range (Using the flash ).
-
To automatically set exposure and focus, press the Shutter button halfway. When the Ready light glows green, press the Shutter button completely down to take the picture.
-
Use Auto, Landscape, or Close-up to adjust the exposure compensation.
|
Picture is not clear
|
-
To automatically set exposure and focus, press the Shutter button halfway. When the Ready light glows green, press the Shutter button completely down to take the picture.
-
Clean the lens ().
-
Make sure camera is not in Close-up mode if you are more than 27.6 in. (70 cm) from your subject.
-
Place the camera on a flat, steady surface or use a tripod, especially in high-zoom settings or in low light.
|
Previous
Next