Kodak EasyShare photo printer 300 — User's Guide

Table of Contents > Getting started > Installing and removing the color cartridge

---

1 Getting started

Installing and removing the color cartridge

1. Open the cartridge door on the side of the photo printer.
		2. Check to make sure there is no slack in the color cartridge ribbon. To remove slack, push in on the cartridge spool, then rotate the spool clockwise. IMPORTANT: Be careful not to rotate the spool more than necessary. Doing so could reduce the number of prints you are able to make.
		3. Slide the color cartridge in, label side up, with the arrow pointing toward the photo printer. Push the cartridge until it "clicks" into place.
		4. Close the cartridge door.

IMPORTANT:

The color cartridge may lock in place if there is a paper error. Do not attempt to remove the cartridge without first clearing the paper error. Make sure the Paper light is off before attempting to remove the cartridge (see Paper light under Photo printer status lights).

			To remove the color cartridge, open the cartridge door, then push up on the green lever and slide the cartridge out.

		When 5 or fewer prints remain, the Color cartridge light blinks slowly for several seconds.
		When the color cartridge is depleted, the Color cartridge light glows steady red. After installing a new color cartridge, press the On/Off button to clear the cartridge error and resume printing.

Previous Next