Kodak EasyShare wireless digital picture frame — User's guide


Table of Contents > Changing frame settings > Upgrading your firmware

4 Changing frame settings

Upgrading your firmware

Firmware is the software that runs on your frame. Upgrade the firmware so you always have the newest features and improvements. To check for the latest version, visit www.kodak.com/go/digitalframedownloads.

NOTE: Upgrading the firmware returns the frame settings to factory defaults.

Manually upgrade firmware

Download the firmware to your computer, then upgrade your frame:

  1. On your computer, go to www.kodak.com/go/digitalframedownloads.

  2. Follow the screen directions to download the frame firmware to your computer.

  3. Copy the IMG file to a memory card or USB flash drive, then insert into the frame; or, connect your computer and frame with the USB cable and copy the IMG file directly to the frame. See Copying between your frame and computer for copying files.

  4. With the IMG file on the frame, press Home , then select Settings and press OK.

  5. Select Upgrade Firmware and press OK to begin the upgrade.

    When the upgrade is complete, your frame automatically restarts. If it doesn't, press the power switch on the frame to Off, then back to On.

    IMPORTANT: Do not turn off the frame during the upgrade!

Automatically upgrade firmware from the Internet

When the frame is connected to your wireless network, you can automatically upgrade the firmware from the Internet whenever a new version is available.

A message appears on your frame when a new firmware version is detected from the Internet.

Upgrade right away

  • Install now—Select, then press OK to start the upgrade.

    When the upgrade is complete, your frame automatically restarts. If it doesn't, press the power switch on the frame to Off, then back to On.

    IMPORTANT: Do not turn off the frame during the upgrade!



Upgrade later

  • Remind me later—Select, then press OK.

    The upgrade message disappears, then appears again the next time you turn on the frame.

  • No thanks—Select, then press OK.

    The upgrade message disappears. To change your mind and upgrade to this version, see Manually upgrade firmware.

    A new message appears when the next firmware version is available.



Previous Next