KODAK EASYSHARE Digital Frame — S730

1 Getting started

Setting the clock, energy saver, and timer

If this is the first time you turned on your frame, the Time/On Off screen appears automatically after you select your language. Follow steps 3, 4, and 7 below.

To change or set the clock, date, energy saver, and automatic timer later, follow all the steps below.

1. Tap (Menu), then tap the down arrow to highlight (Settings). Tap OK.
2. Tap the down arrow to highlight Time/On Off, then tap OK.
		3. Set the clock. Tap the down arrow to highlight Clock, then slide or tap between the left/right arrow lights to select the current time (based on a 24-hour clock).
		4. Set the date. Tap the down arrow to highlight Year/Month/Day, then slide or tap between the left/right arrow lights to select the current date (three separate settings).
5. Set Energy saver. Energy saver automatically turns off the frame after 16 hours of play. You can change the time to 8 hours or disable the feature. Tap the down arrow to highlight Energy saver, then slide or tap between the left/right arrow lights to select 8 or 16 (default) hours. To disable Energy saver, select 24 hours. NOTE: Energy saver is disabled when you set the automatic On/Off Timer. Energy saver is available on frames with firmware dated September 2009 or later. To check your frame's firmware version and date, , Settings, About this frame.
6. Set automatic on and off times. Specify the times you want your frame to automatically turn on and off. NOTE: Make sure the on time is earlier than the off time. Tap the down arrow to highlight On/Off Timer, then tap a left/right arrow light to change the option to Enabled. Tap the down arrow to highlight Turn Frame On At, then slide or tap between the left/right arrow lights to select the On time (based on a 24-hour clock). Tap the down arrow to highlight Turn Frame Off At, then slide or tap between the left/right arrow lights to select the Off time (based on a 24-hour clock).
7. Tap OK to save your settings and close the Menu screen. To close the screen without saving, highlight Exit, then tap OK.

If your frame loses power for an extended period of time (longer than 12 hours), the clock time returns to the factory setting, and the automatic on/off times, if set, are disabled. To reset the clock and re-enable your on/off times, see Resetting the clock and calendar after losing power.