KODAK ESP 1.2 All-in-One Printer — Extended User Guide
Table of Contents > Maintaining Your Printer > Replacing the printhead
9 Maintaining Your Printer
Replacing the printhead
IMPORTANT: | Replacing the printhead is not a regular maintenance procedure. Replace the printhead only if you receive a new printhead from Kodak. |
To replace the printhead:
-
Make sure your printer is on.
-
Lift the access door, and wait for the carriage to move to the access position.
-
Remove both ink cartridges and set them aside.
-
Unlatch the printhead by pushing the button in the center of the carriage.
-
Lift the printhead out of the carriage .
-
Remove the new printhead from its bag.
-
Remove the protective cap from the new printhead.
-
Install the printhead into the carriage.
-
Push firmly against the target label of the printhead until you hear a loud snap.
-
Insert the black ink cartridge into the printhead.
-
Press down on the ink cartridge until you hear a click.
-
Repeat steps 10 - for the color ink cartridge.
-
Close the access door.
The printer detects the new printhead. Follow the instructions on the control panel to calibrate your printer.
Previous Next