Kodak EasyShare printer dock 4000 — User's Guide


Table of Contents > Getting Started with Your Camera > Docking and Charging the Camera

2 Getting Started with Your Camera

Docking and Charging the Camera

Docking your camera lets you print directly from the camera, transfer pictures from the camera to the computer, and charge the camera battery.

  1. Make sure the battery is installed in the camera. See your camera user's guide for details.

  2. On the camera bottom, locate the connector.


  3. Turn off the camera, and place the camera in the printer dock, then push down to seat the connectors. For the DX3215 and DX3700 cameras, turn the camera off again after you place it into the printer dock.

Charging begins immediately.

The camera is now powered by the printer dock instead of the camera battery.


  • The Kodak EasyShare Ni-MH rechargeable battery pack takes 2.5 to 3.0 hours to fully charge.

  • After the battery is charged, leave the camera in the printer dock to maintain the full charge.


  • The three green charging lights monitor the charging status (see Printer Dock Status Lights).

    1—Battery is less than half charged.

    2—Battery is more than half charged.

    3—Battery is fully charged.

    NOTE: Fully charge the battery before first use in the camera.



Previous Next