Kodak EasyShare printer dock plus — User's Guide
Table of Contents > Setting up your EasyShare digital camera > Docking and charging your EasyShare digital camera
2 Setting up your EasyShare digital camera
Docking and charging your EasyShare digital camera
Docking your Kodak EasyShare digital camera lets you review and print pictures directly from the camera, transfer pictures from the camera to the computer, and charge the camera battery.
1.
Make sure a dock insert is installed on the printer dock (see Installing the custom camera insert), and a dock-rechargeable battery is installed in the camera (see Choosing the right camera battery).
|
|||
|
|||
|
3.
Place the camera on the printer dock, making sure to align the dock connector and locator hole with the camera connector and locator pin
. Push down to seat the connector.
Keep the camera wrist strap clear of the paper path to the front and rear of the printer dock. The camera is now powered by the printer dock instead of the camera battery. |
|
|||
|
|
||
|
Refreshing the Ni-MH rechargeable battery pack
If you are getting fewer than 20 pictures per charge with your Ni-MH rechargeable battery pack, follow the tips under Extending battery life. If these don't help, the battery pack needs to be refreshed. The refresh cycle completely discharges the battery pack, then fully recharges it.
NOTE: | A full refresh cycle can take up to 8 hours, depending on how much charge is left in your battery pack. For best results, refresh the battery pack overnight; do not interrupt the discharge/recharge cycle. |
1.
Make sure the Ni-MH rechargeable battery pack is in the camera.
|
|||
|
3.
Press and hold the Battery charging lights/Refresh button, , until the Battery charging lights begin flashing green (approximately 5 seconds).
|
The charging lights monitor the refresh status: |
Descending blinking green lights
|
Discharging battery pack (lights turn off as discharging progresses). |
Ascending steady green lights
|
Charging battery pack (lights turn on as charging progresses). Charging is complete when all three lights are lit. |
NOTE: | Refreshing works with the Kodak EasyShare Ni-MH rechargeable battery pack only; Li-Ion batteries do not require refreshing. |
Previous Next