Kodak EasyShare printer dock plus — User's Guide

  1. Make sure Kodak EasyShare software is installed (see Installing the software) and the printer dock is connected to your computer (see Connecting to a computer).

  2. Open the accessory door on the printer dock.

  3. If a Kodak EasyShare camera is docked, remove it.

IMPORTANT:

Insert card only as shown. Do not force the card into the card slot. Do not insert or remove a card when the printer dock is transferring pictures or if the USB device connector light is blinking.

  4. Orient the card as shown, then push the card into the SD/MMC card slot to seat the connector.

The SD/MMC card slot light blinks while the printer dock reads the card.

  5. Press the Transfer button, , on the printer dock.

Kodak EasyShare software opens on your computer (if it is installed).

  6. Use Kodak EasyShare software to transfer pictures from the printer dock to your computer. See the Kodak EasyShare software Help for details.

The printer dock Transfer light blinks while the pictures are being transferred. The Transfer light continues to blink until the Transfer or Print button is pressed, or until the connection times-out.

NOTE:

With the software installed, connecting the printer dock to the computer establishes a new drive connection for the internal card reader. Pressing the Transfer button lets you view, copy, delete, and otherwise manage files on the new drive, as you do with other drives on your computer. See your computer documentation for details.

• To stop transfer, press the Cancel button, .