Kodak EasyShare G600 printer dock — User's guide
Table of Contents > Maintenance and firmware upgrade > Upgrading your printer dock firmware
8 Maintenance and firmware upgrade
Upgrading your printer dock firmware
IMPORTANT: | To upgrade the firmware, your printer dock must be powered by the AC adapter (not the printer battery). |
From your computer
Connect your printer dock to your computer (see Connecting to a computer). Download the latest version of the printer dock firmware (the software that runs on the printer dock) to your computer. Visit www.kodak.com/go/printerdockdownloads.
From your USB flash drive
-
Transfer the latest version of the printer dock firmware file from your computer to your USB flash drive System or Service folder.
-
Connect your printer dock to the AC power adapter (see Connecting the power), and dock your camera to the printer dock (see Docking and charging the camera).
-
Connect the USB flash drive to your printer dock's USB device connector (see Printing pictures from a USB flash drive).
The printer dock automatically checks the firmware file version on the flash drive.
-
Press Print, , on your printer dock to begin the firmware upgrade.
To exit the firmware upgrade process, use the buttons on the printer dock to select Exit on the camera.
-
Follow your camera's on-screen instructions.
The Red-eye, Transfer, and Print buttons blink until the upgrade is complete. Blinking stops approximately 5 seconds after the upgrade is complete.
-
Remove the USB flash drive and power your printer dock off, then on again.
Previous Next