KODAK ESP C315 All-in-One Printer — User's Manual
Table of Contents > Copying > Copying a photograph
7 Copying
Copying a photograph
You can copy a photograph using the default settings, or you can adjust the quantity, size, quality, and brightness of your copies.
Using the default settings to copy a photograph
The default settings are either the factory default settings (see Resetting factory defaults), or defaults that you have set on the printer (see the bottom of the table under Adjusting the settings and copying a photograph).
To copy a photograph using the current default settings:
-
Load photo paper into the printer (see Loading photo paper ).
-
Lift the scanner lid, and place the photograph face down in the right-front corner of the scanner glass.
-
Close the lid.
-
Press Home.
-
Press to select Copy Photo.
-
Press Start to begin copying.
Adjusting the settings and copying a photograph
To copy a photograph using settings other than the default settings:
-
Lift the scanner lid, and place the photograph face down in the right-front corner of the scanner glass.
-
Close the lid.
-
Press Home.
-
Press to select Copy Photo, then press OK.
-
Press to select an option, then press or to change the setting.
Changing the number of copies of a photograph
To change the number of copies:
-
Lift the scanner lid, and place the photograph face down in the right-front corner of the scanner glass.
-
Close the lid.
-
Press Home.
-
Press to select Copy Photo, then press OK.
-
Make sure Quantity is selected.
-
Press or to select a number.
-
Press Start to begin copying.
Enlarging or reducing a photograph
To enlarge or reduce the size of the copy:
-
Lift the scanner lid, and place the photograph face down in the right-front corner of the scanner glass.
-
Close the lid.
-
Press Home.
-
Press to select Copy Photo, then press OK.
-
Press to select Copy Size.
NOTE: Make sure that the paper loaded in the input tray is at least as wide as the Copy Size selected or you will get a wrong paper size error. Also, if the loaded paper is not as long as the Copy Size selected, the output picture will be cut off without any warning.
-
Press or to select the copy size.
-
Press Start to begin copying.
Darkening or lightening a photograph
To darken or lighten the copy:
-
Lift the scanner lid, and place the photograph face down in the right-front corner of the scanner glass.
-
Close the lid.
-
Press Home.
-
Press to select Copy Photo, then press OK.
-
Press to select Brightness.
-
Press to select a number below zero for a darker copy, or press to select a number above zero for a lighter copy.
Previous Next